As the compact -type terminal OBJ DO and to connect with the personal computer microcomputer and so on
Sequencer operation mode
As the operation board which connected with the mechanical sequencer control system and was improved
Terminal mode
It is the mode to use a teaching terminal as the console like usual terminal ( the keyboard + display equipment ) which uses a RS232C.
Use
For the NC making machine, the robot, the positioning unit, the indicators, the data input such as the measurement receptacle
Specification
Graphics mode
320 X 240 dot
Character mode
Half corner 40 letter X 15 line
Kanji 20 letter X 15 line
Keyboard
48 keys
Direct stop
Output of the outside of the independence
switching switch
With the key
Interface
RS-232C
Sequencer operation mode
The operation board so far manufactured BOX with the sheet metal and the installation of command SW the pilot lamp and so on, the wiring by them were terrible.
By using a teaching terminal, it solves this with one cable.
Because the condition of the machine can be plainly for the screen displayed, anyone becomes able to do the operation of the machine.
It is possible to do hand operation easily and it is convenient because it is a compact type.
The screen can be simply designed by the support tool which works on the personal computer.
It is preparing the form of the numerical value, letter and graph lamp message.
It is possible for the letter, the line, the rectangle, the arc and the circle to display a graphic.
System example
It conforms the receipt of the system, too.
Consult casually.
